Keohi HDTV

 

 

Powered by Keohi Web Design

[INTERFACES]

Red Push Attenuator

There are times when one of the component out signals is a bit more intense in relation to the other signals.  Most of the time, it is the red component.   To correct this problem, you can purchase attenuators.  Depending on the severity of the push, typically a 3db attenuator is all that's needed.

The attenuator is a relatively a small unobtrusive device that is installed inline with the component output with the push problem. From the source (red in this instance) to the attenuator, then from the attenuator to the component input of the set. There are more sophisticated versions that have a potentiometer that allows one to vary the amount of signal attenuation.

Here are just some of the sources for such:

  • radioshack
  • mcmelectronics.com
  • allelectronics.com
  • partsexpress.com